Types of Garage Lights Available on the market!

CITRUS HEIGHTS, Calif. - Dec. 26, 2017 - PRLog -- Type of garage lights

With the development of the economy, almost all households are using cars, and more and more car garages have appeared in compliance with the demand. Because the underground parking lots need continuous lighting all the year round, but the garage is mostly in a car free and unmanned state, which results in the waste of electric energy and the high loss rate of light source.

In response to this phenomenon, other special sensors have been developed to reduce the waste. At present, sensors used in parking lot lighting are basically divided into two types, one is infrared sensor and the other is low price, but the infrared sensor has a certain blind area due to the high level of metal tube and radiation angle. A microwave sensor, can overcome the shortcomings of the blind detection angle, but the price is slightly higher, two kinds of sensors and LED lights together, can realize the lighting of the underground parking lot effectively. When someone in the car lights around when LED lighting is full rate operation, to meet the lighting needs when unmanned vehicles, light in a dormant state, to maintain a low power of about 3W, to maintain the minimum illumination required in the implementation of safety lighting, lighting energy saving, the saving rate can reach more than 80%. Another kind of sensor is radar induction. At present, the best intelligent lighting scheme is the radar induction LED fluorescent lamp. Before the radar induction LED fluorescent tube came out, the underground garage was usually used as a sound control LED fluorescent lamp or a human infrared induction LED fluorescent lamp. Both of them have some defects. First of all, the sound control LED fluorescent lamp is the sound that detects the surrounding environment through the IMI, and amplifies it. The follow-up circuit is used to detect the trigger signal. It is greatly influenced by the noise of the environment. Induction distance and noises, when the surrounding environment is very noisy, may have light, quiet, may not be triggered by environment, temperature, dust and other relatively large impact. The miconet needs to be revealed. As the sensitivity of sound control is greatly influenced by the environment, it is not suitable to use in the parking lot and can be used in the aisle lighting. Secondly, the human induction LED fluorescent tube has a relatively small distance to the human, and the angle is relatively small. It is greatly influenced by environment, temperature and dust. The distance of induction will be shortened at 37 degrees. The infrared sensing head should be detected, and it is not convenient to install. The infrared induction of human body is not very sensitive because of the lack of sensitivity. It is not suitable to use in the parking lot and can be used in the aisle lighting. The radar sensor LED fluorescent lamp, it overcomes the shortcomings of these two, the principle of radar sensor LED fluorescent lamp is through planar antennas emit electromagnetic waves when moving objects into the electromagnetic environment, wave reflection back, planar antenna receives feedback waveform, the trigger signal detection circuit after continued work. The induction distance is far away, the angle is wide, there is no dead zone, it can penetrate glass and thin plank, and is not affected by environment, temperature, dust and so on. At 37 degree, the induction distance will not be shortened.

Ledsmaster Technology (http://www.ledsmaster.com) Can offer you different types of LED Garage Light (http://www.ledsmaster.com/LED-Garage-Lighting-318.html) to save you on cost and energy.