7 Ways To Prolong The Service Life Of The Sand Making Machine

ARCADE, N.Y. - Nov. 14, 2022 - PRLog -- With the development of economical economy and society, how to prolong the service life of heavy industrial machinery and equipment is one of the important research directions of mining machinery and equipment manufacturers. Sand making machine is the core industrial equipment of sand making production line. How to improve the service life of sand making machine is not only the concern of sand making equipment manufacturers, but also the concern of users. So how to prolong the service life of the sand making machine?

1. The starting sequence of sand making machine and conveying equipment is: discharging, sand making machine and feeding; The crusher must be started without load and can be fed only after the crusher operates normally. The shutdown sequence is the opposite.

2. Close the observation door of the vortex chamber before starting to prevent materials from rushing out of the observation door of the vortex chamber and causing danger.

3. Check the rotation direction of the impeller. From the direction of the feed port, the impeller should rotate counterclockwise, otherwise adjust the motor wiring.

4. The feeding of sand making machine (https://m.zenithcrusher.com/products/crusher/sand-making-...) shall be continuous and uniform. The feeding particles shall be strictly in accordance with the specified requirements. It is forbidden to enter the crusher with materials larger than the specified ones, otherwise it will cause the imbalance of the impeller and excessive wear of the impeller, block the impeller channel and the central feeding pipe, and make the crusher unable to work normally. When large pieces of feeding are found, they shall be eliminated in time.

5. In case of violent vibration and abnormal noise during the operation of the crusher, it shall be shut down for inspection.

6. When the discharging equipment stops, stop feeding in time, otherwise it will crush the impeller and burn the motor.

7. The lubrication of the machine is dry oil lubrication, and the addition amount is 1 / 2-2 / 3 of the bearing cavity. An appropriate amount of grease can be added every working shift of the crusher. After 2000 hours of operation, open the main shaft assembly and clean the bearings in pairs. After 7200 hours of operation, replace the bearings with new ones.