How To Use Your Senses When Troubleshooting Test Equipment

Save time by analyzing broken equipment with nothing but your senses!
 
 
Troubleshooting Test Equipment
Troubleshooting Test Equipment
 
OCEANSIDE, Calif. - Nov. 27, 2013 - PRLog -- By Robert Swink, Axiom Test Equipment Lab Manager

When confronted with a piece of equipment that’s not working, lots of things will be running through your mind. Modern test equipment is, after all, very complex, and lots of things can go wrong with it. Oh, the dreaded equipment that needs repair, where to start?

You may already have some information. The repair ticket might say, “Won’t turn on” or “Display not working.” That’s a good start, but I would suggest that before you open the toolbox or break out the schematics, you gather some troubleshooting information using your senses.  Your senses--sight, hearing, touch, and even smell--can tell you a lot about what’s wrong with the gear and get you started in the right direction.

Sight: Before you even turn on a unit, look for signs of damage. Does the display come on? Is the case scratched or dented? Does it look like the unit has been dropped? Are there markings from previous repairs? The answers to these questions can all provide valuable clues. Once the covers are off, I look for things like charred or missing components, damaged fans, or cables that have become disconnected.

Hearing: Once I get to the point of actually turning the equipment on, I listen. Sounds are key. Do I hear any clicks or pops or other unusual noises? Do I hear the cooling fans turning? Is the unit beeping? Some units will beep when they power up successfully, and if it doesn’t, you know something is amiss. Other units might emit a series of beeps when the power-up diagnostics detect a problem. The actual sequence could be valuable troubleshooting information.

Touch: Touching equipment can also yield some valuable information. Be careful, though. Some surfaces might be hot. When touching a faulty unit, check for signs of over-heating, loose components or connectors that could cause intermittent problems. I also put my hand near the exhaust ports and feel for airflow. Low airflow could raise internal temperatures and cause failures or measurement errors.

Smell: Smell may be the easiest way to detect that components got hot enough to burn. The smell of a burnt resistor is unmistakable. In addition, I smell for mold and the carbon smell that indicates that there’s been an insulation breakdown somewhere. By smelling you might even detect a dead animal! One TWT amplifier that I had to work on just reeked. When I took the covers off, I discovered a dead mouse in the far right corner of the amplifier.

Taste: I’d recommend you think twice before running any taste tests on equipment!

So, remember, when it’s time to get in the repair mode, use your common sense(s). I would say that about 1/3 of the time, maybe more, using my senses gets me going in the right direction and makes troubleshooting problems easier.

How have you used your senses to troubleshoot problems? Please share any tips and / or suggestions on techniques that you use on our company Facebook (https://www.facebook.com/pages/Axiom-Test-Equipment/12961...) page.

At Axiom Test Equipment (http://www.axiomtest.com), our job is to ensure that you get the most out of your test equipment. If you have any questions about test equipment repair or preventive maintenance, please feel free to contact us via email at repair@axiomtest.com or phone 760.806.6600 and ask for Robert our lab manager.

Contact
Erin Lee
***@axiomtest.com
760-806-6600
End
Email:***@axiomtest.com Email Verified
Tags:Troubleshooting Equip, Test Equipment Repair, Used Test Equipment
Industry:Electronics, Engineering
Location:Oceanside - California - United States
Account Email Address Verified     Account Phone Number Verified     Disclaimer     Report Abuse
Axiom Test Equipment News
Trending
Most Viewed
Daily News



Like PRLog?
9K2K1K
Click to Share