Time Mark Alternating Controllers Available! Protect Your Equipment Today!

Time Mark Alternating Controllers are used to sequence pumps, compressors, etc., to insure that each receives an equal amount of run time. Duplex (2-pump) versions are socket-mounted, triplex (3-pump) and multi (4-pump) versions in surface mount.
 
June 29, 2010 - PRLog -- ALTERNATING CONTROLLERS
FROM TIME MARK CORPORATION

TULSA, OK – Time Mark Alternating Controllers are used to sequence pumps, compressors, etc., to insure that each receives an equal amount of run time.  Duplex (2-pump) versions are socket-mounted, triplex (3-pump) and multi (4-pump) versions are in surface mount enclosures.

Time Mark’s Model 2611 Alternating Controllers are microprocessor-based designs for use where two loads are required to alternate for equal run time. LED indicators show status of the unit's three contact switch inputs and two load outputs. The controller's lead select switch allows loads to alternate normally in the center position, or disable automatic sequencing and lock in a 1-2 or 2-1 sequence. When a Stop, Lead, or Lag switch closes - corresponding LED atop the Model 2611 illuminates.

Time Mark’s Model 442 Multi-Stage Alternator is designed to control the operating sequence of multi-stage motor/pumping systems. Four motor select DIP switches located on the front panel allow the alternator to control a single-motor/pump, two-motor/pump, three-motor/pump or four-motor/pump system. Motors are sequenced “Sequence-On, Simultaneous-Off ”. If the motor/pumping demand requires only one motor/pump at a time, the alternator will start the next motor/pump in sequence each time an input switch is closed. Input switches may be float switches, pressure switches, flow switches, etc., as required by the application.

Time Mark Corporation, manufacturers of 3-phase monitors, current monitors, voltage sensors, pump and liquid level controls, surge protective devices, instrumentation controls, and Signaline timing devices.  

Contact a Time Mark Sales Representative about our entire line of Alternating Controllers at
www.time-mark.com or by calling 800-862-2875.


Time Mark Corporation
11440 East Pine Street, Tulsa, OK 74116 USA
Toll Free:  800-862-2875            Fax: 918-437-7584               sales@time-mark.com

# # #

Time Mark Corporation are manufacturers of 3-Phase monitors, current monitors, voltage sensors, pump and liquid level controls, alternating relays, and Signaline timing devices.
End
Time Mark Corporation PRs
Trending News
Most Viewed
Top Daily News



Like PRLog?
9K2K1K
Click to Share