News By Tag Industry News News By Place Country(s) Industry News
| Application skills, computer's sound card solutionDefault output driver for the "mute." Click the sound icon bottom right corner of the screen (small loudspeaker), appear to adjust the volume slider below the "mute" option, click the check box in front to clear the check mark box
By: www.sales-battery.com Common reasons for this failure occurs are: 1. Default output driver for the "mute." Click the sound icon bottom right corner of the screen (small loudspeaker) 2. Soundcard conflict with other cards. PnP card solution is used to adjust system resources so that all cards without disturbing each other. Sometimes, open the "Device Manager", although no yellow exclamation point (conflict markers), but the sound is not audible, it is actually in conflict, but the system did not check out. 3. After installing the Direct X sound card is not audible. That this sound card with Direct X compatibility is not good, need to update the driver. 4. One channel silent. Check the sound card to the audio speaker cable is disconnected. Troubleshooting II: excessive noise from the sound card Common reasons for this failure occurs are: 1. Card is not correct. Manufacturing precision is not high enough because the chassis, sound card manufacturer or installed outside the damper caused by bad sound card can not be closely integrated with the motherboard expansion slots, can be seen visually on the card "Goldfinger" 2. Active Speaker Speaker input connected to the sound card output. For the active speaker, should be connected to sound card Line out side, it has not been output signal amplifier on the card, the noise is much smaller. There is only one output card is the Speaker or Line out jumpers on the card depends on the decision, the factory default is often Speaker, so the jumper to disconnect the sound card. 3. Windows comes with a bad driver. Sound card driver is installed, you should select the "drivers provided by the manufacturer" Troubleshooting III: Sound can not "plug and play" 1. To make use of a new driver or alternative procedures. I once had a sound card under Windows 98 using the original driver disk to install the driver install does not matter how, and had to replace the use of Creative SB16 driver, everything is normal. Then upgrade to Windows Me, not normal and back with Windows 2000 (full version) comes with just the normal sound card drivers. 2.'s Most vexing problems than the Windows 9X Plug and Play device under test has chosen to given a free hand to help you install the driver, the driver side is not used, then, will reload every time you repeat the delete problems, and can not use the "add new hardware" solutions. Here I reveal a secret detached trick: Go to Win9xinfother directory, the *. inf file on the sound card, delete all and restart manually after installation, this was one hundred percent efficacious, have saved countless lives ... ... of course, sound card, change up table can achieve the same purpose. 3. Does not support the PnP sound card installed (also applies to not use the PnP install the PnP sound card): Go to "Control Panel" / "Add new hardware" / "Next" when prompted "requires Windows search for new hardware? ", select" No ", then select from the list," Sound, video and game controllers "with a driver disk or directly select the sound card type to install. Troubleshooting four: Play CD silent 1. Completely silent. With Windows 98's "CD player" put CD silent, but the "CD player" and work at the normal, indicating that a CD-ROM audio cable is not connected. Using a 4-pin CD-ROM audio cable to connect the analog audio output and CD-in on the card can be, this line will purchase CD-ROM included. 2. There is only one channel sound. Optical output signal generally about two lines, the middle two lines to ground. Because the audio signal line 4 line color is generally different, the color can be found from the line correspond to the interface. If only one interface or sound card and audio cable for each interface does not match the wiring had to change the order of the audio line, usually only one of two lines of the change can be. Troubleshooting V: PCI sound card appears sonic boom PCI cards are generally used because of technical causes Bus Master PCI bus hung in the hard disk read and write, mouse movements and other operations to enlarge the background noise's sake. Solution: Turn off the Bus Master PCI card features into AGP graphics card, sound card for the PCI slot. Troubleshooting six: not the normal recording First check if there is nothing wrong with the microphone jack into the other, and second, double-click the little speaker, select menu "Properties → recording" to see if the settings are correct. Then in the "Control Panel → Multimedia → equipment" adjustment "mixer device" and "Line equipment", set them to "use" status. If the "Multimedia → Audio" in the "Record" option is grayed It would be bad, of course, is not without room for saving, you can try the "Add New Hardware → Systems and Equipment" in addition "ISA Plug and Play bus "simply the sound card with the card to restart after the installation tool. Seven common fault: Can not Play Wav Music, Midi Music Can not play Wav music phenomenon is rare, often due to "Multimedia" 1. Early ISA sound card may be due to the 16-bit mode and 32-bit mode is not compatible with MIDI playback is not caused by normal wave form by way of installing software should be able to resolve 2. Today, most of the popular PCI sound card with wavetable synthesis technology, if the MIDI playback is not part of it is likely because you do not load the appropriate wavetable sound library. 3. Windows volume control in the MIDI channel is set to silent mode. Troubleshooting eight: PCI sound card is not normal in the use of WIN98 Some users complained that the sound card driver installation process everything is normal, no device conflicts occur, but the following is not aloud in WIN98 or cause other problems. This phenomenon usually occurs in the PCI sound card, please check the installation process your PCI sound card inserted in the article which PCI slot. Thermal considerations for some friends, like to stay away from the sound card inserted in the AGP slot, near the ISA slot that several PCI slots. The problem often arises here, because there is a Windows98 Bug: sometimes only correctly identified and inserted in the PCI-1 PCI-2 sound card two slots. ATX motherboard in the two next to AGP is the PCI-1 PCI and PCI-2 (the opposite in some ATX motherboard, close to the ISA is the PCI-1), so if you do not have the PCI sound card installed in the correct the slot, the problem will arise. Professional battery shop-------- http://www.shop- CANON NB-9L battery http://www.shop- CANON bp-511a battery http://www.shop- # # # Www.shop-batteries.com A leading online battery superstore: a complete store and information site for laptop batteries, camcorder batteries, digital camera batteries, adapters, chargers, and so on. If you have any suggestions for our battery or service, you can email to customer service department, your help will be great appreciated! End
|
| |||||||||||||||||||||||||||||||||||||||||||||||||||
