Follow on Google News News By Tag Industry News News By Location Country(s) Industry News
Follow on Google News | Pineberry Manufacturing Inc. to Exhibit Automation Solutions at PACK EXPO InternationalIn the South Building of the McCormick Place, Pineberry Manufacturing Inc. will be exhibiting at PACK EXPO International in Booth S-3470, Equipment on Display at PACK EXPO International: 6 Ft Conveyor with Autoloader and Rotary feeder A custom system that feeds plastic or paper "lid," "Card," "Leaflet," or any other media (observing the limitations of size and shape) through a rotary feeder system will pick the "media" using suction caps and then drop it onto a vacuum conveyor. The vacuum from the conveyor will hold the "media" in place while it passes underneath a Herma label applicator. The applicator will place a "label or a patch" onto the "carrier media" (in the same place each time). Once the "Label or patch" has been applied to the "carrier media," it will pass under a camera system that will a) verify if the label or patch is present. This system will run at approx. 120-150 carriers per minute. Pineberry Cobot MG400 Model The MG400 is an ultra-compact desktop-grade robotic arm with a footprint smaller than a piece of A4 paper. It is safe for human collaboration, easy to use, and quick to deploy, making it perfect for automating small-batch flexible productions. With a 750 g maximum payload, 440 mm maximum reach, drag-to-teach, and collision detection features, the MG400 is a cost-effective option for innovative automation tasks. It will be used on the tradeshow as a demo unit, and the cobot arm will pick samples and media, small boxes to envelopes where a few subtracts from one position will be picked and moved to another position 90 degrees distant using a suction cap gripper. 1648 C – SF12L Feeder with Dot Jet Printer The product is stacked in the feeder magazine and dispensed as a single product from the loaded stack. The operator sets the batch size. The product is fed through the feeder exit. During product travel, a Dot jet printer installed in the exit conveyor belt senses the product and prints a preset fixed or variable message or barcode. A sensor counts the product as it exits the feeder. When the product level in the magazine drops below a set level, the low pile sensor will trip. The product can be continuously replenished in the magazine on the fly without stoppages. This system has a catch tray and a remote trip sensor; removing the product from the catch tray will trip the next batch to feed. A remote trip option is available for integration with other systems. For inquiries, reach out to us at (844)746-3634 / (905)829-0016. https://pineberryinc.com/ End
Account Email Address Account Phone Number Disclaimer Report Abuse
|
|