News By Tag
News By Location
Follow on Google News
UltraFlex induction soldering assembly for an electronics manufacturer within mere 3 sec
Besides being a time- and cost-efficient process, induction soldering would guarantee the customer consistent, repeatable results every time, regardless of the operator skills.
UltraFlex engineers considered UltraFlex induction heating equipment from the UltraHeat SM series as most efficient for this soldering scenario. UltraHeat SM is a compact 5 KW induction heater operating with either a water-cooled or air-cooled remote heat station. It can efficiently operate in a wide frequency range, which was important for this heating application.
The soldering process was started by placing a solder ring under the joint. High-acid solder flux was applied around the joint to clean it of any residual oxides and guarantee a good connection between the parts. Heat was then applied onto the head of the pin so the heat would transfer down and focus on the areas needed rather than spread to other areas.
Thanks to the focused heat, the soldering process was completed within the customer-targeted time of 3 seconds. The joint obtained had been reliable and clean.
Besides being a time- and cost-efficient process, induction soldering would guarantee the customer consistent, repeatable results every time, regardless of the operator skills. Finally, due to the lack of open flame, smoke and noxious emissions, the manufacturer would be able to achieve a completely safe process - safe for the operator, safe for the environment.
Find out more at:
Contact us at:
About UltraFlex Power Technologies:
UltraFlex Power Technologies (ultraflexpower.com)
UltraFlex Power Technologies