Conos Electric Screwdriver in India for a discount price of Rs.11,880/-
Save up to 50% on Conos Torque Controlled Electric Screwdriver RE-4800P in India. Buy it at a price of Rs.11,880/- from the original earlier price of Rs.21,600/- by INDE Enterprises.
By: INDE Enterprises
• Low DC voltage operated
• Torque range: - 0.8 ~ 16 kgfcm - 0.08 ~ 1.6Nm - 0.7 ~ 13.9lbf.in
• Push-to-Start type
• Free speed: 660 rpm
CHANGING THE BIT
Pull the collet ring towards the body of the electric screwdriver and insert the desired bit. Release the collet ring and the bit will be automatically locked into position.
Twist the torque nut towards the body of the driver in a clockwise motion for more tension/ torque. Twist the torque nut away from the body of the driver in a counter clockwise motion for less tension/ torque.
LOCK OUT RING
The torque setting can be locked in by removing the spring band from the torque adjusting nut and inserting a set screw. The set screw is included with every new driver.
Plug the adaptor driver directly into a 220V power outlet or connect to the T-1-CL HL controller. Twist the locking ring on the male connector clockwise to lick the connection in place.
Apply light axial pressure through the tool onto the fastener. Squeeze the trigger to start and run down the fastener. When reaching preset torque, the tool will stop automatically. When releasing the trigger the tool is once again ready for use. Please make sure the tool, the axial pressure and the fastener are all in a straight line. Tilting the tool will result in irregular stops and may damage the fastener.
If a screw is properly set, slide the forward/ reverse selector found on the back shoulder of the tool into the reverse position and apply pressure to the lever.
If the red "overload" light illuminates on the T-1-CL HL controller this indicates the system is being used beyond its recommended capacity. Please reduce the torque setting on the driver or extended use can result in permanent damage to the motor and gear set.
We recommend replacing the carbon brush set every 400,000 cycles or a minimum of 1x per year and greasing the front gear set at the same interval. If properly maintained the driver will offer long term reliability for your application needs.
745, Sector 8-B, Chandigarh 160009 (India)