HVAC Monitoring Saves School Building Significant Costs
CAS DataLoggers supplied the wireless data logging solution for a middle school maintenance supervisor who needed to perform power factor correction on the building's HVAC system before winter arrived. The school needed a lightweight yet affordable HVAC monitoring system that could connect to most available power meters to measure the system's pulse output. The supervisor also needed this device to be compatible with other data logging models to measure other parameters in future, including temperature from ducts, the humidity of the airstream from vents, etc. A wireless solution would be ideal to provide coverage in remote spots. Early on in the selection process, the supervisor realized that he was also going to need some technical support to get his project up and running ASAP before autumn arrived and heating costs rose.
The school installed four T&D RTR-505-P Wireless Pulse Data Loggers along with an RTR-500 Wireless Base Station (https://www.dataloggerinc.com/
The compact T&D pulse data loggers recorded the changes in pulse count for the thermostat and switch contact signals and the Lo/Hi voltage signals that occurred during the user-set recording interval. The remote units also allowed for a wide variety of commercially available sensors to be connected to the included input module, widening the range of measurable values. Measuring voltage signals from 0 to 27V with a pulse response with a low of 0.5V or less, high of 2.5V or more, and a maximum pulse rate of 3,500 pulses per second, the data loggers could each store 16,000 readings to keep logging for extended periods. The loggers' clear LCD displays showed current readings along with status, logging capacity, measurement range exceeded, and more, and the dataloggers also offered options for wall brackets for permanent installations.
Using the T&D monitoring system (https://www.tandd.com/
Utilizing a low energy consumption design, the data loggers' lithium batteries had an estimated battery life of about 10 months operating at normal temperature. If the contractor needed to extend logging duration, T&D "L" model loggers featured a large capacity battery pack so that under the same conditions they could continue for about four years to save workers the trouble of replacing the battery.
The middle school's wireless system was installed in late summer and began identifying areas for energy savings by mid-autumn. The data loggers and the wireless base station proved to be a cost-effective HVAC monitoring solution for the school's energy monitoring project, and data collection and organization was a snap with the loggers' wireless capability.
For more information on T&D RTR-505-P Wireless Pulse Data Loggers (https://www.dataloggerinc.com/