Nov. 23, 2012
-- For this problem, perhaps a lot of people would say: That goes without saying you instructions not. Yes, the manual does say very clearly 2,3,4,5 gear speed 20,40,60,70 about, but from time to time to observe the speed table to select the gear, but also a bit tedious, especially the complex sections, eyes always observed outside the complex, it is difficult to draw out the eyes to observe the speed table, and then how to solve for the good? I have a little experience, and is willing to share with you, of course, only the manual transmission, the automatic driver not delay you.
In fact, the method is very simple, moving [http://www.motor-
Reader-p-241.html U581 LIVE DATA OBD2 EOBD Scanner Can-Bus Code Reader] the right foot depresses the accelerator suddenly heels to completely, [http://www.motor-tools.com/U695-Japanese-Car-Professional...
U695 Japanese Car Professional Scan Code Reader] the car is traveling in case of no oil, if you feel the speed with the foot lift suddenly decelerate, description low gear, should be elevated a block, then a small step on the gas, and then suddenly heels to complete, if you feel less than deceleration or deceleration is small, the gear and speed to match, only speed and gear match the fuel consumption is minimal, driving in this state, you will feel right foot do not always step on the accelerator, when you step on loose, the car is intermittent with a sliding block, Hath Do not fuel-efficient or Down? This is my summary point step on the gas, to determine reasonable gear. Of course, this is for general driving, If you encounter overtaking or downshift, high speed to the speed of the cosine of the sword, and roared when overtaking, it is not necessary to use this method. Skilled operators do not have frequent throttle feel of you know that the gear is appropriate.