4 Steps to Revive a Dead Rechargeable Battery

Sept. 21, 2010 - PRLog -- There are 4 steps to revive the dead rechargeable battery such as laptop battery. Over time, the battery will be rechargeable lose their ability to continue to work, a charge anymore. This happens due to overcharging, making it very hot or very cold and many others. You may think that since it can not be charged, you must recycle and they just buy a newbattery. Instead, follow these steps to revive the battery with a small dose of high capacity and low voltage hits it quickly back to life.
The tools you need

* Dead Battery
* Multimeter
* Welding
* Insulated gloves
* Safety glasses

Step 1. Check the battery levels

First, check the equipment that recharges the Makita Drill Battery (http://www.notebook-batteries.net/power-tool-battery/makita/index.htm)to make sure they are the reason for the battery is not charging. If not you will need to use to verify the multi-charge of the battery. In most cases, the reading shows that the effort is much less than it says on the screen. If you have a battery backup of making one, you can use this measure to determine the battery power should have after the resurrection of the dead one.
Step 2. Verification of equipment levels

Welding test your multi to make sure the DC power adapter, and is also used to check whether the gun is positive or negative. Welding can sometimes be a check that is polarized is the inverse of that you need to run key in the multi-welding Special until he tells you that you are making about 30 volts.
Step 3. Off battery

This can be a very dangerous procedure because you will use the high voltage current in this step. With the Bosch Drill Battery of the dead, and make sure you wear goggles and safety gloves isolated, press the positive end for welding to your station, plus the batterywhile holding the end of the negative terminal of the battery minus. When you use this technique to make sure you are not soldering on the battery. Just click at the end of welding to the positive plus on the battery and shock see some sparks if done correctly. What this does is force a large amount of current in the cell that vaporized dendrite, such as reducing valves. You can also use this same technique on a battery that may be worn, which distinguishes the peel to get to the cells. Then use the tool to sand off a busy materials and then go to them welding or car battery.
Step 4. Test Battery

Now when the battery is replaced once again to the application that you are using you will see that the  bosch  Drill Battery (  http://www.notebook-batteries.net/power-tool-battery/bosc... ) will be much better than it used to be. Although the use of the starting battery will also have some consequences. And start from the dendrite means another one will be close behind, as well as materials that have been vaporized now permeated the separator material that forms the resistance, which can short plates. The cell also can not be reduced and will be charged with retainer of the poor.

notebook battery please visit:  http://www.notebook-batteries.net

# # #

http://www.notebook-batteries.net --- sell high quality and low, discount price laptop batteries,notebook batteries, digital camera batteries, Cordless Drill Batteries, camcorder batteries, laptop AC/DC adapters and battery chargers. etc