EUK179 - Elau Servo motor press release
The ERIKS solution has been welcomed by engineers because Elau Servo Motors require extremely specific diagnostic and repair facilities. This is because the commutation devices are in constant communication with the drive, and therefore cannot be dynamically tested using anything other than the Elau Pac-Drive MC-4 servo controller.
Elau Servo Motors use a hiperface encoder; this carries an eeprom that contains the motor data that the drive utilises to run the motors in an Elau Pac-Drive system. If this eeprom is programmed incorrectly the motor will not run in the Pac-Drive system. However, following extensive reverse engineering of Elau Motors and the Elau MC-4 Pac-Drives, the ERIKS team has successfully developed the capability to programme and test these motors.
For further information, please contact: Robyn Bradley, Marketing Executive, ERIKS UK
T: +44 (0)121 508 6219 (tel:%2B44%20%
-END-
This press information was written and distributed by 4CM (http://www.4cm.co.uk/)
About ERIKS UK
We offer over 90 years technical knowledge and experience from 76 nationwide industrial service centres, supplying over 500,000 unique industrial products. We have 88 integrated on site stores and procurement centres reducing the costs of all maintenance and repair products and industrial services. With 9 core competence centres and 23 fully equipped repair workshops maintaining equipment from electric motors, pumps, gearboxes, generators, transformers through to condition monitoring based preventative maintenance services, such as thermography, air leak surveys and vibration analysis.
Photo:
http://www.prlog.org/
