Follow on Google News News By Tag Industry News News By Location Country(s) Industry News
Follow on Google News | Beta LaserMike Brings New 3-Axis Fault Detection and Lay Length Measurement to Wire DusseldorfNew three-axis Lump & Neckdown Detector provides more precise measurement for improved flaw detection. New LayScan system measures cable lay lengths with highest accuracy.
By: Jay D. Luis Beta LaserMike will debut its new three-axis LN Detector. This advanced, compact system provides more precise detection of short-term faults (lump and neckdowns) in the product diameter than two-axis systems. The three-axis scanning system offers a higher degree of coverage around the product’s circumference to instantly detect sudden changes in the surface. The LN Detector can measure products up to 15 mm (.59 in) in diameter at line speeds up to 3000 m/min (9842 ft/min). It can accept a range of inputs including length encoder, tachometer, line start/stop, and clear faults and can be connected to a host PC or PLC using Ethernet IP, Devicenet, Profibus, and Profinet. Data capture capabilities enable you to report critical process information such as height, length, number, and location of the flaw. Beta LaserMike’s will also show its new LayScan measurement system (patent pending). This innovative gauge accurately and consistently measures the lay length of twisted pairs used in telecommunication cables. The system uses optical, non-contact measurement technology to perform on-line, high-speed lay length measurements with accuracies to 0.0254 mm (0.001 inch). LayScan provides high-data rate capabilities to precisely determine the variations in lay length within each lay. Systematic lay variations that are typically caused by twinning and cabling operations can be readily observed and measured. A data acquisition system effectively collects and processes the lay length data and reports the measurement results. In addition, Beta LaserMike will exhibit the following non-contact measurement and controls solutions: • CenterScan 2010 eccentricity measurement system • AccuScan diameter gauge • LaserSpeed length and speed gauge • High-Frequency Spark Tester and Pre-heater systems • BenchMike table-top cut sample measurement system • DataPro process controller and data management system • SRL Pro on-line structural return loss (SRL) prediction and analysis system # # # About Beta LaserMike Beta LaserMike is a global organization committed to the innovation, design, manufacture, and service of precision measurement and control systems for a wide range of non-contact measurement applications, including building products, non-woven materials, paper, plastic, wire and cable, fiber optics, pipe and tube, primary metals, and dimensional metrology. Learn more at www.betalasermike.com. End
Account Email Address Account Phone Number Disclaimer Report Abuse
|
|