essential to permit its mechanical And Application To Steel Just Released

May 30, 2010 - PRLog -- Hobart, Washington USA   May 31, 2010

Heat Treatment Zone  has just released a new section of their website that contains all the information regarding Heat Treatment Zone. This is a part of a new community website that is all about Heat Treatment. Members and non-members can visit freely to the website at: http://heattreatmentzone.com/.  

Here is an excerpt from Heat Treatment Zone Information Webpage:

"Heat treatment - being applied to steel, is the process of heat application to steel in order to change its condition or characteristics. The quantity of heat may be calculated through the coldness or hotness of the steel that is being treated. Temperature may either be hot or cold if touched; therefore the procedure of treating temperature may range from very cold to very hot. The range of temperature may be from negative cold to hot plus.

Heat application to steel is very essential to permit its mechanical, properties and conditions to change in order to enable the steel to operate both during production or its functional life cycle.

The ferrite situation in iron is comparable to water or H2O to be exact. Water exists into three forms: liquid, vapor and ice. Any of these conditions or phases is still water, however, each of them exist in diverse crystal form. Likewise, ferrite is a single condition of iron.

During the application of heat to iron, things start to occur to the glossy section of steel which is being heated. The oxygen around the atmosphere starts to respond with glistening face of iron to form into Iron Oxide. As temperature increases, the response between oxygen and iron happens to be more insistent and noticeable product starts to form in the face of iron known as scale.

By the time the steel arrives at estimated temperature at 1,350xF, a transformation in the composition takes place also the phase. The stage transforms from ferrite into austenite. Furthermore, the crystal composition converts from cubic which is body-centered into face-centered cubic structure. A sign of the transformation happening is that there is a loss of magnetic property of the ion, that can be witnessed by testing the face of steel by a magnet. Be careful to secure your hands and fingers if testing for magnetism that was lost from the heated steel.

The crystal composition changes to cubic structure that is face-centered when the iron heated reaches to above the lower converted temperature of 1,350xF. Thus, in creating the stage of austenite, sufficient heat is needed to make the phase."


There is plenty of more available information on the new general information of Heat Treatment Zone website that can be found by visiting at: http://heattreatmentzone.com/. They have a special offering that is currently going on that permits the members to get access on ebooks and other free materials just for signing up as member of Heat Treatment Zone website for free at: http://heattreatmentzone.com/. Users must check back regularly to Heat Treatment Zone general page for new information is being added all the time.

About Us: Heat Treatment Zone is an active community website that consist a lot of information with regards to Heat Treatment Zone. We will appreciate it if you join the site and share your knowledge and experience in this network.