zj20 fluid processing system
A. Solids separation in oil and gas field
Solids separation equipments is always referring as solids control equipments in oil and gas field, and it is a very important part that separate the solids from drilling fluids. It concerns Drilling Pits and Enviromental Protection, and gives more functions to drilling system.
B. Solids separation equipments
1. shale shaker
Shale Shaker is the first class solid-control equipment which is the latest development in GN Solids Control company to treat the drilling mud. Linear motion shale shaker is installed with the imported vibration motor power and is currently the most advanced shaker in our country. The shale shaker have many advantages, which are high vibrating strength, wide screen size, screen angle adjustment, compact, high performance, cost-effective. Shale shaker for solids control are devices that remove drill cuttings from the drilling fluid while circulating and drilling. The basic design consists of large, flat sheets of wire mesh screens or sieves of various mesh sizes that shakes or vibrates the drill cuttings, commonly shale shaker, across and off of the screens as the drilling fluid flows through them and back into the drilling fluids processing system, often called a mud system.
http://www.gn-
2. desander desilter
Desander, as stated earlier, have no moving parts. The larger the internal diameter (ID) of the desander is, the greater the amount of fluid it is able to process and the larger the size of the solids removed. Desander (10 in.cone) are able to remove roughly 50 percent of those solids within the 40-50 micron range at a flow rate of 500 gallons per min (gal/min), while desilter (4 in. Cone) are able to remove approximately 50 percent of those solids within the 15-20 micron range at a flow rate of 60 gal/min. Micro fine separators are able to remove around 50 percent of those solids within the 10-15 micron range at a flow rate of 15 gal/min. Desander is typically positioned next-to-last in the arrangement of solids control equipment, with decanting centrifuge as the subsequent processing unit. Desander are preceded by gas busters, gumbo removal equipment (if utilized), shale shakers, mud cleaner (if utilized) and vacuum degasser.Desander is widely used in oilfield drilling.
http://www.gn-
3. decanting centrifuge
Decanter centrifuge are used to process unweighted and weighted, water-based and oil-based drilling fluids (muds). Decanting Centrifuge are able to apply over 3,000 G-forces on the liquid/solids mixture, which separates the heavier solids from the lighter solids. Additionally, high G-forces separate fine solids from liquid. Mechanical separation of solids from the mud system through the use of a decanter centrifuge is a highly-effective means of maintaining proper mud weight and viscosity. When used in conjunction with other Solids control equipment, decanting centrifuge enable users to maintain the mud properties within the prescribed range as per the drilling program. Typically,oilfield decanting centrifuge is the final processing units in the arrangement of solids control equipment. Decanting centrifuge preceded by gas busters, gumbo removal equipment (if utilized), shale shakers, mud Cleaners (if utilized), Vacuum degassers and hyrdocyclones.
C. Why choose GN Solids Control
Firstly, I will introduce you the principle of GN Solids Control: Only Top Quality Products! This is our promise!
Secondly, GN Solids Control supply all the parts of solids control system, including shale shakers, desanders, desilters, mud tank separation, centrifugal pumps, decanting centrifuges and so on, and GN supply all the products right as you required.
http://oilfield.gnsolidscontrol.com/
Photo:
http://www.prlog.org/
