Touch Screen LCD Monitor
If the long row shows a fixed content, there is a certain
number of pixels could lead to overheating, thus causing internal burn, resulting in dead pixel. This damage is irreversible
and can not be repaired. Therefore, we should pay attention when used: nothing can be dry, close the monitor; if it is only
temporary, nothing to do, on the choice of screen saver. Or reduce the display's brightness a little, you can also let the
screen all white;, but this only protects the LCD, behind the fluorescent tubes still worked, so I am more in favor of the
direct correlation of the display, be the end.
This is very different and the CRT!http://www.global-
there is no big deal; and LCD display principle is totally not the same as with CRT monitors. It is a direct one
correspondence of pixels displayed. Work under the best resolution of LCD monitors to display graphics output analog signal
by processing, conversion into a zone of specific address information (the pixels on the screen of the absolute address) of
the display signal, and then into the LCD panel, directly to the display signal added to the corresponding pixel on the drive
pipe, some with memory addressing and write is similar. If the video card on DVI, direct output to the LCD digital interface,
this new display there is no pixel loss, the graphics output signal perfectly displayed. However, less than the best
resolution in the display screen, the liquid crystal display is used to display in two ways, one is centered shows such as
the best resolution is 1024 × 768 LCD display 800 × 600 resolution in the time , it is only the middle of its 800 × 600
pixels to display images compared with the surrounding shadows, http://www.global-
correspondence, so a clear picture, the only regret is that the screen is too small; and another type is expand the way, that
is, 800 × 600 images by calculating the means expanded to 1024 × 768 resolution to display, since this approach is not a
post-signal and pixel-one correspondence, although the big screen, but rather ambiguous. Either display is not ideal, so I
strongly recommend taking the recommended maximum resolution!
In the final analysis, different principles should be used to monitor the maintenance of different methods, liquid crystal
display is the best way break off the display.
In short, the process of using liquid crystal displays, we should pay extra care of her, had abandoned the use of CRT
monitors Datailielie defects will be good practice to keep the original. Using recommended best resolution, so that to
achieve the best display. If the maintenance of better words, a liquid crystal display is fully capable to spend more than
ten years. Lastly, I hope you can use a good good care of your LCD monitor to your work and life more fun!
http://www.global-
Photo:
http://www.prlog.org/
