Before you decide to start your towing trip, it’s a wise decision to look over the brief checklist - for safety’s sake. You take a good look inside your mirrors, adjusting them correctly so that you can see passing traffic while traveling. You’ve chosen the suitable hitch and connected the towing vehicle to the trailer properly. The brake lights and braking systems are working synchronously, assuring you of the ride’s legality. With everything loaded up, you’re pretty confident the truck is ready to make the job, so you head out on the road toward your destination. Once you reach a steady speed, however, the trailer behind your truck starts to bounce and sway a tad bit more than it should. Pulling over to the side of the road, you rack your brains to figure out that which you missed. You begin to wonder in the event that your cargo weight is maybe too high - but what else could you do about it?
http://www.youtube.com/
In this situation, if there’s too much cargo weighing down a towed vehicle, causing everything to rock and sway, the issue may be with the suspension. If a truck’s suspension is too rigid, its wheels will often leave the pavement after hitting bumps; a good suspension, nevertheless, keeps the wheels on the ground as much as possible. Many towers use leaf springs to stabilize their towed load and to keep their cargo grounded.
Although you may not ever commonly hear about or even noticed leaf springs on larger tow vehicles, the technology has been around for centuries and is one of the earliest forms of suspension. Even Leonardo da Vinci used leaf springs in his diagram for a self-propelled car. But how do they work? Are there numerous kinds of leaf springs? And how do you install them onto a vehicle?
Compared to most automotive technology currently available, leaf springs don’t look too fancy. They’re simply long and narrow plates attached to the frame of a trailer that rest above or below the trailer’s axle. Slightly curved, they look a little like a metal bow from an archery set, except without the string. Leaf springs come in several different varieties. You will discover monoleaf springs, or single-leaf springs, that consist of simply one plate of spring steel. These are usually thick in the middle and taper out toward the end, and they don’t typically offer too much strength and suspension for towed vehicles. Drivers looking to tow heavier loads typically use multileaf springs, which incorporate several leaf springs of varying length stacked on top of each other. The shorter the leaf spring, the closer to the bottom it will be, passing it on the same semielliptical shape a single leaf spring gets from being thicker in the middle.
Leaf springs also have different ends, depending on where they’re connected to the frame. On double-eye leaf springs, the most known plate — and therefore the longest - has both ends curved into a circle. The ends make two holes, that you simply can bolt to the bottom of a trailer’s frame. Open-eye leaf springs have just one “eye,” or open hole. The other end of an open eye leaf spring can be quite a hook end or a flat end.
For more details, please visit our website: http://www.strutmasters.com/
