Concrete expression of the resistance is bigger, at charging time at both ends of voltage rise faster, so it will be easily found for the charge control
circuit has been filled, the capacity also is naturally "down". Since relatively large battery internal resistance, discharge voltage drop by high speed, the
system can easily mistaken for a voltage not enough, lack of electricity (in fact, there is no electrical discharge). As can be seen from the above
description of the battery is a vicious cycle of aging process, the discovery of lost working hours, the battery faster than when what it should be tempered,
or else it will end sooner or later http://www.bestlaptopbattery.co.uk/
bad pot of soup mouse droppings. This phenomenon can not be avoided, because the battery power-saving core of each character can not be fully consistent with
a long time there are some quality, the aging first weakened, undermining the whole (series after) the discharge curve. It simply means that section of bad
batteries before charging full discharge also finished first place, but this time the capacity of the other batteries have not been fully utilized. The core
of a power-saving over charge / over-discharge will not cause the battery monitoring circuit that the whole is full of / discharge end of the. For example,
when charging other batteries start getting close to full charge when pressed, that section of bad batteries may have reached the terminal voltage of 4.30V
or higher, resulting in overcharge damage, while others are sufficient dissatisfaction.
Editor's note: For internal batteries battery damage, the "Chinese
computer education" 2001 No. 2 has a very good article - "notebook computer batteries DIY" worth learning from. Interest, courage and capacity of friends can
try to open the battery pack, believe that the help of multimeter, you can quickly find the damaged batteries (voltage abnormality)
according to the corresponding parameters of the replacement batteries can be qualified product. The battery charge and discharge Rechargeable lithium-ion
battery when the first way to fast charge constant current in the voltage reaches a certain value and then to slow charging constant voltage mode. Notebook
computers are often not strictly a constant-current charge of monitoring devices. The system load when a large charge current on small, whereas the large,
the current from the AC power adapter power margin decision. Clearly, the system will charge the battery and other components, such as CPU, hard drive, LCD
and other competing energy sources. http://www.bestlaptopbattery.co.uk/
changes, can not meet the lithium-ion battery charging requirements, so I fear that this will work, rechargeable batteries were defective. IBM statement
calling for notebook computers will not operate when the charge is probably the reason.
Charge at boot time, if we can select the charge mode, you do not choose fast charge mode (Express charge mode), to avoid premature battery "full." There
is a time of low battery power to prohibit the use of the highest CPU performance in order to reduce the power of the competition. If the notebook computer's
CPU is to support the use of SpeedStep technology, it is best to install the driver (the vendor will be responsible installed) to facilitate the adjustment
performance. SpeedStep program icon is a blue flags, right-click performance tuning options it can occur. Under the Windows XP system, SpeedStep program will
be problems, this time to rely on or to modify the BIOS parameters of the regulation of a number of brand-specific programs, such as IBM notebook computer
software is very powerful tool. Electric-
of resistors in the class). Not to say that that was not feasible, but relatively large risk, if the internal protection circuit was not working, then set
aside the batteries, and the worst is probably the battery explosion, of course, this unlikely. Circuit hidden dangerous is not impossible, a number of big-
name manufacturers have found that the design of potential risk factors exist in a battery recall, as mobile phone battery when you do not hear the
explosion. Tip: In general, notebook computer battery protection circuit in the part is usually voltage block, control chip, insurance, and temperature
probes. Temperature protection device is usually a one-off, the inside has a fuse (some 130 ℃ Fuse), is used to monitor the voltage regulator block work. If
the charge-discharge process exceptions, immediately there will be a current through the temperature protection device, will fuse fuse, the battery's
internal circuitry at this time for the open circuit state, and can not be restored. If you want to repair only the replacement of temperature protection
device, but such temperature protection device on the market hard to find. Discharge is the discharge current as small as possible, the operation is to slow
down and let the CPU, hard disk stops turn, transferred the darkest the screen (or close the switch off), then do not run any programs until the laptop
automatically shut down. The emphasis on small-current discharge is to prevent premature detection of laptop battery shortage.
http://www.bestlaptopbattery.co.uk/
Photo:
http://www.prlog.org/




