PRLog (Press Release) -
Mar 18, 2008 -
Pittsford, NY: µDRIVE-
uSD-G1 is a tiny module that can be easily interfaced to any microcontroller project that requires “disk-drive”
data storage. Most microcontroller applications are constrained by the available onboard memory where large volumes of data are concerned. The compact 14.9 x 18.9 x 3.5mm µDRIVE-uSD-
G1 takes memory burdens away from the host controller by allowing data transfers via a simple serial interface.
A few simple commands provide direct access to the onboard micro-SD memory card for handling almost any size or type of binary data. Data storage and retrieval takes place via the auto-baud RS-232 serial interface (300 to 256kbaud). The easy-learn commands can read and write data blocks ranging from a single byte in size to 512 bytes of sectors on 64MB to 2GB SD memory cards.
Helpful on-board LEDs indicate system status (GREEN: Power and Memory Card detect indicator; RED: “Disk Drive” access) and µDRIVE-uSD-
G1 can operate from 3.6 - 6.0 V @ about 25mA. An optional USB to Serial interface board μUSB-CE5 allows USB connection for system firmware updates.
Applications for µDRIVE-uSD-
G1 include data logging, program storage, music/image/
video files, or any general purpose data storage. When a PIC, AVR, ARM, STAMP, Propeller or any other microcontroller application requires data storage, µDRIVE-uSD-
G1 offers an ideal, rapid solution, since it requires only a simple 5 pin interface to the host device (VCC, TX, RX, GND, RESET).
µDRIVE-uSD-
G1 is made in Australia by 4D Systems and is available now from their USA distributor Saelig Co. Inc. at $37.00. 1-888-
SAELIG info@saelig.com www.saelig.com
Hi-Res Image:
http://www.saelig.com/images/udrive-usd-g1300.jpgDirect Link:
http://www.saelig.com/pr/udriveusdg1.htm
